Connecting The Ac Power Cable - Aastra ATP-CNX-020 Installation And Setup Manual

Aastra CNX Quick Installation and Setup Guide
Procedures

Connecting the AC power cable

5
Connect the power cable
Ground the chassis
a. Locate the 3-hole, female, power receptacle on the rear of the chassis.
b. Plug the male, 3-prong connector on the power cable into the power receptacle.
c. Insert the plug at the other end of the power cable into a grounded power source (100 to 240 VAC).
NOTE: North America: 120 V at 15 A
Europe: 240 V at 10 A
100-240 VAC
1.0A 47-63HZ
6
T1 / E1
1 2
AC power cord
3 4
CONSOLE RESET
Connect to a grounded 15 A
power source (100 to 240 VAC).
(North America: 120 V at 15 A)
(Europe: 240 V at 10 A)
ATP-CNX-020 Rel. 1.2, Doc. Rev. 01.06
10/100 ENET
1 2