Table of Contents
Advertisement
Aastra CNX Quick Installation and Setup Guide
Procedures
Step
Action
6
Enter "y" if the network information is correct, and press <Enter>.
Enter "n" if the network information is incorrect, and press <Enter>.
Note: If you entered "n" at the verification prompt, repeat steps 3 through 7 to correct the network
information, and then enter "y" at step 8.
The following message and prompt display (after entering "y" at the verification prompt):
Configuring Domain Name Service (DNS)...
Domain Name:
7
Enter the Default Gateway for the Ethernet port for which you want to use as a management
interface, and press <Enter>. For example:
Default Gateway: 192.168.2.1 ↵
The following displays:
Before the following information is configured, please verify the
information below is correct before proceeding.
Hostname:
IP Address:
Broadcast Address:
Netmask:
Default Gateway:
Is this correct (y/n):
8
Enter "y" if the network information is correct, and press <Enter>.
Enter "n" if the network information is incorrect, and press <Enter>.
Note: If you entered "n" at the verification prompt, repeat steps 3 through 7 to correct the network
information, and then enter "y" at step 8.
The following message and prompt display (after entering "y" at the verification prompt):
Configuring Domain Name Service (DNS)...
Domain Name:
10
cnx1
192.168.2.6
192.168.2.255
255.255.255.0
192.168.2.1
ATP-CNX-020 Rel. 1.2, Doc. Rev. 01.06
(continued)
Advertisement
Table of Contents
