GE PDCS1NBWARSS Owner's Manual And Installation Instructions page 7

About the shelves and bins. gecem
Not all features are on all models.
Some models have wire shelves that
can be adjusted in the same mamTer.
Rearranging the Shelves
Shel',es in the refrigerator ('On_l)artn_ent are a(!iustable.
Refrigerator Compartment
To remove:
0 ]_emoxe all items fl'om the shelf.
0 Tilt the shelf up at the fl'ont.
0 I,ifl the shelf u I) at the back and
b_l"ng the shelf out.
To replace:
0 _,_q_ile tilting the shelf up, insert the top
hook at the back of the shelf in a slot
on the track.
0 I,ower the fl'ont of the shelf tmtil the
bottom of the shelf locks into place.
Spillproof Shelves (on some models)
Spillproof shelves have special edges to
help prevent spills fl'om dripping to lower
shelves. To ren/ove or replace the shelves,
see Rearranging the Shelves,
Slide-Out Spillproof Sheff (on some models)
The slide-out spillproo/shelf allo_:_ you
to reach items stored behind othe_. The
special edges are designed to help prevent
spills fl'om dripping to lower shelves.
Toremove:
0 Remove all items fl'om shelfi
0 Slide the shelf ()tit until it stops.
0 lift the fl'ont edge of the shelf tmtil the
central tabs are above the fl'ont bin:
0 Continue pulling the shelf torward
tmtil it can be removed.
Toreplace:
0 Place the rear shell tabs just in fl'ont of
the central notches on the shelf fl'ame.
Slide the shelf in tmtil the central tabs
are slightly behind the ti'ont bin:
0 i,ower the shelf into place tmfil it is
horizontal and slide the shelf in.
Make sure that the shelf sits flat after reinstallation
and doesn't move freely from side to side.
Make sure you push the shelves aft the way in
before you dose the door
7