Door Swing; Door Alignment - GE Monogram ZFSB23DRKSS Owner's Manual

Additional Features
Stainless Steel IG(/}'igeralor
R@igerator
door6
The refl'igerator cloot_ may feel difl'erent than
the ones you are used to. The special door
opening/closing fl_ature makes sure the doors
close all the way and are securely sealed.
When opening and closing the door wm will
notice a detent position. If the door is opened
past this detent point, the door will remain
open to allow w)u to load and unload food
more easily. When the door is only partially
open, it will automatically close.
The resistance you teel at the detent position
will be reduced as the door is loaded with fi)od.
Whenthe door is onlypartially
open,it will automaticallyclose.
Beyondthis detent the doorwill
stayopen.
Door swing
€l(?(I,r(I,_l cgs
The doors are thctm y set fin" a 160 °
door swing. To avoid contact damage
to the reflJgerator doors or to a@_cent
cabinetry or walls, observe the minim mn
clearances shown.
14-1/4"
______ 19"_
• On the freezer side, allow 14-1/4" rain.
clearance for a flfll door swing and ' , ",,
remoxal of ice bin. _"_........ / '" '')",,
""'-. ..... _'$- )"
• On the fresh tood side, allow 19" rain.
clearance tot a flfll door swing and tot remowd
of drawers.
• Allow 4" rain. clearance on each side to an
a(!jacent wall fl)r a 90 ° opening and access to
drawers. A 90 ° opening will allow the doors to
make contact with ac!iacent walls.
i i ',, i22"
Door
alignment
If dora5 are uneven, a(!just the refl'igerator dora:
1 Using a 7/16" socket wrench, tm'n the door
a(!iusting screw to the right to raise the dora;
to the lett to lower it. (A nylon plug, imbedded
in the threads of the pin, prevents the pin
from tm'ning tmless a wrench is used.)
2 After one or two turns of the wrench, open
and close the refrigerator door and check the
aligmnent at the top of the doors.
\
Toremovethe base
grille, openthe
doors,removethe
screwat eachend
of the basegrille
andthenpull the
grille straightout.
7/16" Socket W rench
Raise
15