Related Manuals for GE ZFSB23DSS
Summary of Contents for GE ZFSB23DSS
- Page 1 Installation Instructions Free-Standing Side-by-Side Stainless Steel Refrigerator ZFSB23D SS ZFSB25D SS monogram.com...
-
Page 2: Table Of Contents
Step 2, Install Water Line ...7 Step 2A, RO Water Line ...8 Safety Information CAUTION: Due to the weight and size of this refrigerator, and to reduce the risk of personal injury or damage to the product – TWO PEOPLE ARE REQUIRED FOR PROPER INSTALLATION. -
Page 3: Planning Information
The water line should be GE SmartConnect tubing between the cold water line and water connection location at the rear of the refrigerator. Installation of an easily accessible shut off valve in the water line is recommended. -
Page 4: Tools Required
Installation Instructions FLOORING For proper installation, this refrigerator must be placed on a level surface of hard material that is at the same height as the rest of the flooring. This surface should be strong enough to support a fully loaded refrigerator. -
Page 5: Step 1, Move Refrigerator Indoors (Zfsb25)
31", the top cap and doors must be removed. NOTE: Skip this step if door removal is not required. See instructions on page 7, “To Move The Refrigerator Indoors.” NOTE: To prevent damage, leave inside packaging, door spacer and outside protective wrap in place until the unit is moved to the installation location. -
Page 6: Step 1A, Move Refrigerator Indoors (Zfsb23)
The top cap must be removed to access hinges. It is best to remove one door at a time. A. Remove 2 screws and springs on top of the refrigerator, one on each side. Push the top cap forward and lift up from the rear. -
Page 7: Step 2 Install Water Line
• Measure the distance from the water valve on the back of the refrigerator to the water supply line. Add 8 foot length to allow the refrigerator to be moved away from the wall after installation. Bend the tubing into 3 coils of about 10". -
Page 8: Step 2A, Ro Water Line
GE RVKit must be used. For other reverse osmosis water systems, follow the manufacturer’s recommendations. If the water supply to the refrigerator is from a Reverse Osmosis Water System, use the refrigerator’s filter bypass plug. Using the refrigerator’s water filtration cartridge with the RO filter can result in hollow ice cubes and slower water flow from the water dispenser. -
Page 9: Step 6, Level Refrigerator
• Rollers adjust to allow the refrigerator to be firmly positioned on the floor and to prevent rocking when the doors are opened and closed. • The rollers allow you to move the refrigerator from the wall for cleaning. To Adjust the Rollers: Roller Adjusting Screw •... -
Page 10: Step 9 Start Icemaker
Installation Instructions STEP 10 TEMPERATURE • The temperature controls are preset at 37°F for the refrigerator and 0°F for the freezer. • Allow 24 hours to stabilize before making adjustments. STEP 11 INSTALL TOEKICK • Press toekick into position and reinstall one screw on each side. - Page 11 Notes...
- Page 12 Pub. No. 31-46518 Part No. 225D1974P002 02-08 JR Printed in Mexico NOTE: While performing installations described in this book, safety glasses or goggles should be worn. For Monogram ® local service in your area, call 1.800.444.1845. NOTE: Product improvement is a continuing endeavor at General Electric.
Need help?
Do you have a question about the ZFSB23DSS and is the answer not in the manual?
Questions and answers