GE Monogram ZFSB23DRKSS Owner's Manual page 25

The Problem Solver
Stainless Steel I_(/)'ig'eralor
Questions ?
Use this
prob#m
solver, t
PROBLEM
FREQUENT
"BUZZING" SOUND
ICE CUBES HAVE
ODOR/TASTE
SMALL OR
HOLLOW CUBES
SLOW ICE CUBE
FREEZING
CUBE DISPENSER
DOES NOT WORK
WATER HAS POOR
TASTE/ODOR
WATER IN FIRST
GLASS IS WARM
WATER DISPENSER
DOES NOT WORK
WATER SPURTING
FROM DISPENSER
POSSIBLE CAUSE
• Icemaker power switch is in the I (on) position, but the water
supply
to the refl'igerator has not been connected. Set the power switch
to the 0
(off)
position. Keeping it in the I (on) position will damage
the water wove.
• Old cubes need to be discarded.
• Ice storage bin needs to be emptied and washed.
• Unsealed packages in fl'esh food and/or fl'eezer compartments may
be transmitting odor/taste to ice cubes.
• Interior of refl'igerator needs cleaning. See Care and Cleaning.
• X*\'ater filter clogged. Replace the filter or use the filter byi)ass plug.
• Door mav have been left open.
• WllYn tellll)eratllre of
fl'eezer
COllll)arti/lent
colder.
See Temperature Controls.
• Icemaker or water supply turned off. Turn on icemaker or water suppl>
• Ice cubes are fl'ozen to the icemaker feeler arm. Remove the cubes.
• hTegular clumps in the storage bin. Break up with fingertip pressure
and discard
remaining
clumps. The fl'eezer may be too warm. A(!just
the freezer temperature control colder one step at a time tmtil clumps
do not t()I'I11,
• The dispenser is I,OCKED. Press and hold the CONTROl, I,OCK pad
fin" 3 seconds.
• An item is blocking or has tallen into the ice chute inside the top
door bin of the fl'eezer. Remove any item that might be blocking
or has tallen into the chute.
• X_hter dispenser has not been used for a hmg time. Dispense water
tmtil all water in the system has been replenished.
• Normal when refl'igerator is first installed. Allow 24 hours fi_r the
refl'igerator to completely cool down.
• _,Vater dispenser has not been used for a hmg time. Dispense water
tmtil all water in the s_stei// has been replenished.
• Water svstem has been drained. Allow several horn's tot the
replenished water supply to chill.
• Water supply line turned off or not connected. See the
Installation lnst_ uctions.
• X4'ater filter clogged. Replace the filter or use the filter bypass plug.
• _dr may be trapped in the system. Press the dispenser arm fin.
at least 2 minutes.
• The dispenser is I,OCKED. Press and hold the CONTROl, I,OCK pad
fin" 3 seconds.
• Newly installed filter cartridge. Run water from the dispenser fin.
about 3 minutes (about 1½ gallons).