Related Manuals for GE Monogram ZFSB27DYSS
Summary of Contents for GE Monogram ZFSB27DYSS
- Page 1 ® GE Monogram Installation Instructions Stainless Steel Refrigerator Model ZFSB27DY SS...
-
Page 2: Table Of Contents
Before you begin—Read these instructions completely and carefully. IMPORTANT: Save these instructions for local inspector’s use. IMPORTANT: OBSERVE ALL GOVERNING CODES AND ORDINANCES. NOTE TO INSTALLER: Be sure to leave these instructions with the Consumer. NOTE TO CONSUMER: Keep these instructions with your Use and Care Book for future reference. -
Page 3: Water Connection Location, Electrical
Installation Preparation Stainless Steel Refrigerator The water line can be routed through Water the floor or through an adjacent cabinet, as Connection close to the back wall as possible. Location, A 115 volt, 60 Hz. 15 or 20 amp power supply Electrical is required. -
Page 4: Grounding The Refrigerator
Installation Preparation Stainless Steel Refrigerator IMPORTANT - (Please read carefully) Have the wall outlet and circuit checked by a Grounding qualified electrician to make sure the outlet is FOR PERSONAL SAFETY, THIS APPLIANCE properly grounded. MUST BE PROPERLY GROUNDED. Refrigerator Where a standard 2-prong wall outlet is encoun- The power cord of this appliance is equipped tered, it is your personal responsibility and... -
Page 5: Step 1, Remove Packaging
Installation Stainless Steel Refrigerator Use a hand-truck to move this refrigerator. To remove the freezer door: Step • To remove the skid, lay the refrigerator on its Open the freezer door and remove the base back and remove the shipping bolts. grille. -
Page 6: Step 2, Install Water Line
Installation Stainless Steel Refrigerator Washer • A cold water supply is required for automatic icemaker operation. The water pressure must Pipe Clamp Step be between 20 and 120 p.s.i. Saddle Type • Route 1/4" OD copper tubing between house Install Shutoff cold water line and the water connection Valve... -
Page 7: Step 4, Connect Power
Installation Stainless Steel Refrigerators • Connect the refrigerator power cord plug to Step properly grounded receptacle. Connect Power The icemaker will not begin to operate until it reaches its operating temperature of 15ºF. S tep (-9ºC.) or below. • Lower the feeler arm to the ON position and Start the icemaker will begin operation automatically. - Page 8 Note: While performing installations described in this book, safety glasses or goggles should be worn. To obtain specific information concerning any ® Monogram product or service, call GE Answer Center consumer information service at 800.626.2000—any time, day or night. For Monogram local service in your area, call 1-800-444-1845.