Page 2
• I1 taut d_brancher le r_frig&'atem" avant Product tailure due to improper installation is not nettoyage ou route intervention. covered under the GE Appliance Warranm See the • I,es r_parations doivent &tre taites par Owner's Manual fin" warranty information. technicien qualifi_. For Monogrmn...
Page 3
Planning Information THE INSTALLATION SPACE PRODUCT DIMENSIONS AND CLEARANCES Tile opening width must be 36-1/2". 27-1/2" _S6-1/2"_ Wall View Electrical Area 73" min. 36" Water And Electrical Locations 29-1/2" Tile oi)ening inust be i)rei_ared with tile electrical Including Handles water sui)ply located as shown.
Page 4
Installation Instructions TOOLS REQUIRED FLOORING • Tinsnips to cut banding For proper installation, this refrigerator must be placed on a level surface of hard material that is at the same • Stepladder • Bucket height as the rest of the flooring. This surface should •...
Page 5
Installation Instructions REMOVE THE DOORS [STEP 1 ]MOVE REFRIGERATOR INDOORS cap must be removed to access hinges. It is best to I'elllOVe door at a tilne. springs on top IMPORTANT: Remove 2 screws of the refrigerator; each side. Push into installation location require...
Page 6
Bend the tubing into 3 coils of about 10", OutletValve (Sleeve) NOTE: The only GE approved plastic tubing is supplied in GE SmartCmmec( '_Refrigerator Tubing kits. Do not use any other plastic water supply line •...
Page 7
Hold the tubing in place and tighten the fitting. If you are using GE SmartCmmect'" tubing: • Insert the molded of tile tubing into tile refl'igerator connection, at tile back of tile refrigerator,...
Page 8
Installation Instructions [STEP 6] LEVEL REFRIGERATOR [STEP 7] LEVEL THE DOORS refl'igerator be leveled by a_!justing If the doors evenly aligned at the top, rollers located near bottom hin_es. refrigerator door can be a(!justed. • Use a 7/16" socket or wrench to turn door ac!justing...
Page 9
Installation Instructions ISTEP91 TEMPERATURE [STEP 8] START ICEMAKER CONTROLS • The temperature controls are preset at 37 ° fi_r the refl'igerator 0°F for the freezer. • Allow 24 hours to stabilize befln'e making a(!justments. ISTEP101 INSTALL TOEKICK • Press toekick into position reinstall one screw...