Broiler Pan And Grid; Oven Light - GE JGRP17 Series Use And Care Manual

CARE AND CLEANING
Proper care and cleaning are important so your oven will give you efficient
and satisfactory service. Follow these directions carefully in caring for your
oven to assure safe and proper maintenance.
Broiler Pan and Grid
After broiling, remove
the broiler pan from the
oven. Remove the grid
from the pan. Carefully
pour out grease from
the pan into a proper
container. Wash and
rinse the broiler pan
and grid in hot water
Y
with a soap-filled or plastic scouring pad.
If food has burned on, sprinkle the grid with detergent
while hot and cover with wet paper towels or a dishcloth.
Soaking the pan will remove burned-on foods.
The broiler pan and grid may be cleaned with a
commercial oven cleaner.
Both the broiler pan and grid can also be cleaned in
the dishwasher.
Do not clean the broiler pan or grid in the self-
cleaning oven.
Do not store a soiled broiler pan and grid anywhere
in the oven.
Removable Storage Drawer
The storage drawer is a good place to store cookware
and bakeware. Do not store plastics and flammable
material in the drawer.
Do not overload the storage drawer. If the drawer
is too heavy, it may slip off the track when opened.
To open the drawer, grasp the center of the handle and
pull straight out.
To remove: Pull the drawer straight out and lift over
the guide stops.
To replace: Lift over the guide stops and slide the
drawer into place.
To clean both the inside and the outside: Wipe with
soap and water. Rinse well.
Do not use cleansing powders or harsh abrasives
which may scratch the surface.
Oven Light Replacement
CAUTION: Before replacing your oven light bulb,
disconnect the electric power for your oven at the
main fuse or circuit breaker panel.
Be sure to let the light cover and bulb cool completely
before removing or replacing them. When in use, light
bulbs can become warm enough to break if touched
with a moist cloth or towel. When cleaning, avoid
touching warm lights with cleaning cloths if the light
cover is removed.
The oven light (bulb) is covered with a removable
glass cover which is held in place with a wire. Remove
the oven door, if desired, to reach the cover easily.
To remove:
• Hold your hand under
the cover so it doesn't
fall when released. With
fingers of the same hand,
firmly push back the
wire cover holder. Lift
off the cover.
Wire cover holder
DO NOT REMOVE ANY SCREWS.
• Replace bulb with 40-watt home appliance bulb.
To replace cover:
• Place it into the groove of the light receptacle. Pull
the wire forward to the center of cover until it snaps
in place. When in place, the wire holds the cover
firmly. Be certain the wire is in the depression in the
center of the cover.
• Connect electric power to the oven.
(continued next page)
25