Problem Solver - GE JGRP17 Series Use And Care Manual

Built-in gas oven
Hide thumbs Also See for JGRP17 Series:
Table of Contents

Advertisement

QUESTIONS?
USE THIS PROBLEM SOLVER
PROBLEM
"F-AND
A NUMBER
OR LETTER"
FLASH
IN THE DISPLAY
CLOCK AND TIMER
DO NOT WORK
CONTROL
SIGNALS
AFTER
ENTERING
COOKING
TIME
OR DELAY START TIME
DISPLAY
GOES BLANK
DISPLAY FLASHES
UNABLE
TO GET THE
DISPLAY
TO SHOW "SF"
"'LOCK DOOR"
FLASHES
"'LOCKED DOOR" FLASHES
OVEN LIGHT DOES
NOT WORK
OVEN WILL NOT SET
A SELF-CLEAN
CYCLE
OVEN NOT CLEAN
AFTER
CLEAN
CYCLE
DOOR WILL NOT
OPEN AFTER
SELF-CLEAN
CYCLE
POSSIBLE
CAUSE
• This is a function
error code. Press CLEAR/OFE
Allow the oven to cool one
hour. Place the oven back into operation.
• Disconnect
all power to the oven for 5 minutes
and then reconnect
power. If the
failure code repeats, call for service.
• Check for power outage .......
• This is reminding
you to press BAKE and then enter a temperature.
• This is reminding
you to enter a bake temperature
after having pressed BAKE.
• This is reminding
you to close the oven door so the self-clean
cycle can start.
• The circuit breaker in your house has been tripped, or a fuse has been blown.
• Power failure. Reset the clock.
• BAKE and BROIL HI/LO must be pressed
at the same time and held for
2 seconds.
• Oven door not closed after self-clean
cycle is selected.
• Door is still locked and you are trying to enter an oven cooking operation.
• The light bulb is loose or defective.
Tighten or replace.
• The pad operating the oven light is broken.
Call for service.
• Oven temperature
is too high to set self-clean
operation.
Allow the oven to cool to room temperature
and reset the controls.
• Oven door not fully closed.
• If the self-cleaning
mode malfunctions,
turn the oven off and disconnect
the
power supply. Have it serviced by a qualified technician.
• Oven controls not set properly.
See the Operating
the Self-Cleaning
Oven section.
• Heavily
soiled ovens require 4 to 5 hours of clean time.
• Heavy spillovers
should be cleaned
up before starting clean cycle.
• When the temperature
has fallen below the locking temperature
door can
be opened.
(continued
next page)
29
_o
€_Jo

Advertisement

Table of Contents
loading

Table of Contents