GE JGRP17 Series Use And Care Manual page 23

How to Set the Oven for Cleaning
Easy Steps:
1. Press SELF CLEAN.
2. Press the HOUR and MIN + or - pads to set the
clean time.
3. Press START.
1. Follow the steps in the Before a
Clean Cycle section.
2. Press SELF CLEAN.
\ 3. Press the HOUR and M1N + or -
pads to set the clean time, if a time
HOUR MIN
other than 4 hours is needed.
_ Clean time is normally 4 hours. You
can change the clean time to any
time between 3 to 5 hours, depending
on the amount of soil in your oven.
NOTE:
4. Press START.
°
The door locks automatically. The display
will show the clean time remaining.
It will not be possible to open the oven
door until the temperature drops below
the lock temperature and the LOCKED
DOOR light goes off.
When the LOCKED DOOR light is off,
open the door.
• You can find out when the clean cycle will
start by pressing DELAY START.
• The display will flash and the control will
beep if you set the clean cycle and forget
to close the oven door.
How to Set Delay Start of Cleaning
Easy Steps:
1. Press SELF CLEAN.
2. Press the HOUR and MIN + or - pads to set
the clean time.
3. Press DELAY START.
4. Press the HOUR and MIN + or - pads to set
the start time.
5. Press START.
Delay Start is setting the oven to start the clean
cycle automatically at a later time than the present
time of day.
NOTE: Before beginning, make sure the oven clock
shows the correct time of day.
1. Follow the steps in the Before a
Clean Cycle section.
2. Press SELF CLEAN.
d_r/_ 3. Press the HOUR and MIN + or -
pads to set the clean time.
HOUR MIN
4. Press DELAY START.
HOUR MIN
Press the HOUR and MIN + or -
pads to set the time of day you want
the clean cycle to start.
Press START.
The door locks automatically. The
display will show the start time. It
will not be possible to open the oven
door until the temperature drops
below the lock temperature and the
LOCKED DOOR light goes off.
7. When the LOCKED DOOR light is
off, open the door.
(continued next page)
23
©
¢/o
©
<