GE JGRP17 Series Use And Care Manual page 7

Built-in gas oven
Hide thumbs Also See for JGRP17 Series:
Table of Contents

Advertisement

OVEN CONTROL, CLOCK AND TIMER
Clock
The clock must be set for the automatic
oven timing functions
to work properly.
The time of day clock cannot be changed during Delay Start. (It can be changed
during a regular bake or broil operation.)
To Set the Clock
1. Press CLOCK.
(/_
(/_,,,
2. Press the HOUR and MIN
pads to set the time of day.
HOUR
MIN
+ or-
3. Press START. This enters the time and
starts the clock.
To check the time of day when the display is
showing
other
information,
simply press CLOCK.
The time of day shows until another pad is pressed.
Timer
You may program
the timer to time cooking or other
household
activities
for up to 9 hours and 59 minutes.
The timer counts down in minutes, 1 mimite at a time,
until the last 60 seconds are reached, then the control
will beep one time. The seconds will not be displayed
until the last minute is reached.
When the timer reaches " :00," the control will beep
3 times followed
by one beep every 6 seconds until
KITCHEN
TIMER ON/OFF
is pressed.
The 6 second tone can be canceled
by following
the
steps in the Special Features
of Your Oven Control
section under Tones at the End of a Timed Cycle.
How to Set the Timer
1. Press KITCHEN
TIMER ON/OFF.
(_(_
2. Press the HOUR and MIN + or -
pads until the amount of time you
HOUR
MIN
want shows in the display.
_
If you make a mistake,
press
KITCHEN
TIMER ON/OFF
and begin again.
3. Press START.
After pressing
START, "SET" disappears;
this tells you the time is counting
down,
although
the display does not change until
one minute has passed.
4. When time is up, the oven control signals
until you press KITCHEN
TIMER
ON/OFF. Display then shows the time
of day.
NOTE: The minute timer is independent
of all the
other functions
and it does not control the oven.
The CLEAR/OFF
pad does not affect the timer.
Power
Failure
If a flashing
time of day is in the display, you have
experienced
a power failure. Reset the clock.
To reset the clock, press CLOCK.
Enter the correct
time of day by pressing
the HOUR and MIN + or -
pads. Press START.
(continued
next page)
7
©
©
BlWe

Advertisement

Table of Contents
loading

Table of Contents