Troubleshooting - Zoom MultiStomp MS-50G Operation Manual

The unit will not turn ON
to the INPUT jack to start the unit.
No sound or very low volume
Check the connections (!P6).
Adjust the levels of the effects being used (!P8).
Confirm that unit is not in mute mode (!P19).
There is a lot of noise
Check shielded cables for defects.
Use only a genuine ZOOM AC adapter (!P6).
An effect is not working
If the effect processing capacity is exceeded,
"DSP Full!" appears on the effect graphic. In
this case, the effect is bypassed (!P9).
Batteries lose their charge quickly
Confirm that you are not using manganese
batteries. Alkaline batteries should provide
about 7 hours of continuous operation.
Check the battery setting (!P6).
Set the type of battery being used to enable
the remaining charge to be shown more
accurately (!P20).
Due to the characteristics of the batteries,
they might be used more quickly in cold.
29

Troubleshooting