Advertisement
Troubleshooting
● No sound or very low volume.
・ Confirm that the device and PC are connected via the USB cable.
・ Properly connect the guitar to the INPUT terminal, and the headphone
to the PHONE (or OUTPUT) terminal.
・ To adjust the sound volume, turn the PATCH LEVEL knob in
Edit&Share.
・ Adjust the Gain parameter and Level parameter of the amplifiers and
effectors used in Edit&Share.
・ When adjusting the volume with an expression pedal, make sure that a
suitable volume setting has been set with the pedal.
・ Adjust the master level of the device.
・ Check the device settings.
● There is a lot of noise.
・ Check the shielded cables that you are using for defects.
・ Adjust the Gain parameter and Level parameter of the amplifiers and
effectors used in Edit&Share.
・ Check the expression pedal settings. Depending on parameters as-
signed for the expression pedal, extreme changes to parameters
caused by operating the pedal may result in noise.
● The device is not recognized by the computer even though they
are connected by USB.
・ Confirm that the OS you are using is supported.
・ If the name of the device does not appear, open the Display menu,
select Show Devices, and put a check next to the device name.
・ When the device list is improper, click Connect > Refresh from the
Device menu to update the list.
● The effector does not work.
・ Confirm that the effector is turned on (LED is lit.) Edit&Share screen.
・ Check whether the device has been bypassed.
● The device does not reply to Edit&Share while editing.
・ Please restart Edit&Share if you computer have turned into sleep mode.
Note : Edit&Share does not support sleep mode. Please do not use
sleep mode.
● A setting value of an imported patch has changed
・ When a patch created in G3 Ver.1.12 or earlier is imported into G3 Ver.2.00
or later, a maximum limit is applied to the time setting of delay effects. If
a patch with a delay time setting that exceeds maximum is imported, that
setting will be changed to the maximum value.
Maximum delay time limit applied to patches imported from G3 Ver.1.12 or
earlier into G3 Ver. 2.00 or later.
Effect type
Time setting before import
2501 or higher
×10 or more
2501 or higher
×10 or more
1251 or higher
×4 or more
2501 or higher
×10 or more
*TimeL/TimeR
1001 or higher
×4 or more
*DlyTime
1501 or higher
×6 or more
Time setting after import
2500
×10
2500
×10
1250
×4
2500
×10
1000
×4
1500
×6
12
Advertisement
