Advertisement
I. General
This camera is smoke detectors built with B/W CCD cameras
for discreet surveillance. It comes with B/W CCD camera that
delivers clear and sharp picture for side viewing; and it is easy
to change different lenses to adopt the best view angles for
security need. This camera can simultaneously install up to 4
cameras, which is most economic and effective for video
surveillance.
II. Precautions
• Do not expose the camera to humidity and dust. Outdoor
application without shielding is not recommended.
• Handle with care. This camera consists of sensitive high
precision parts. Do not disassemble or install it on an
unstable base.
• Operate on +12VDC. Use a regulated power source only.
• Never face the camera toward the sun directly.
III. Installation Instructions
The horizontal view angle of the Smoke Detector Camera is
1.
78-degree. Decide the location to install the camera.
Full-Screen Width of View
= 1.6 X Distance between
Camera and Target
2. Visually inspect the contents to ascertain that no damage
occurred during shipping.
3.Plug in the attached video and power cable to the camera
connector.
4. Connect the video output of the camera to a monochrome monitor
or other video device through a 75 ohm type coaxial cable with
BNC female connector at cable extension.
5. Connect the +12VDC regulated power source of the camera to
the DC 12V Power-in jack with 2mm, center+, outer-plug.
6. Adjust the direction of the lens as per needed.
78°
IV. Installing More Cameras
This camera can accommodate up to 4 B/W CCD cameras. Please
refer to the following steps to install the other cameras.
P/N: MSM1G0030A VerB
Advertisement
