Table of Contents
Advertisement
You may use the DIP switch included in the Model 1069 for configuring
the CO or CPE mode. All other configurations for the Model 1069 VDSL2
CPE should be made through the VDSL2+ DSLAM.
4.1 CONFIGURING SWITCH S1-1: CO/CPE
The DIP switches are externally accessible from the underside of the
Model 2174. Figure 7 on page 13 shows the orientation of the DIP
switches in the On and Off positions.
Use switch S1-1 to configure the unit as a CPE (Remote unit) or CO
(Local unit).
4.0 CONFIGURATION
S1
Figure 7. DIP switch orientation
Table 1: Local/Remote Unit Configuration
S1-1
ON
CPE/Remote
OFF
CO/Local
Setting
13
Advertisement
Table of Contents
