Operation; Front Panel Led Status Monitors - Patton electronics OnSite 1069 User Manual

Once the Model 1069 is properly installed, it should operate transpar-
ently. No user settings required. This section describes reading the LED
status monitors.
Before applying power to the Model 1069, please review section 3.4,
"Connecting Power" on page 12 to verify that the unit is connected to the
appropriate power source.

5.1 FRONT PANEL LED STATUS MONITORS

The Model 1069 features six front panel LEDs that monitor power, the
Ethernet signals, the VDSL2 connection, and the remote/local setting.
Figure 8 shows the front panel location of each LED. Table 2 on page 14
describes the LED functions.
LED
Power
Green
Off
DSL
Green
Blinking Green
Off
CPE
Green
Off
Ethernet
Green
*
Blinking Green
*.
Once the unit connects to a power source, the Link LED will blink
as the 1069 automatically looks for the other unit.

5.0 OPERATION

Power
Figure 8. Model 1069 front panel
Table 2: Front panel LED description
Status
The device is powered on.
The device is powered off.
The port is connected.
Data transceiving.
No valid link on this port.
The device is operating in CPE (Remote) mode.
The device is operating in CO (Local) mode.
The port is connected.
Data transceiving.
™
Ethernet Link
CPE (Remote) Mode
DSL Link
Description
14