Table of Contents
Advertisement
TABLE OF CONTENTS
Section
1.0 Warranty Information .............................................................2
2.0 General Information ...............................................................4
2.3 SNMP Management Soulutions
3.0 Configuration .........................................................................6
4.0 Installation ...........................................................................26
5.0 Operation .............................................................................30
Appendix B - V.35 Terminal Interface Pin Assignments ..............35
- RS-232 Terminal Interface Pin Assignments ........36
Appendix C - Control Port Pin Assignments ...............................37
Appendix D - Line Interface Pin Assignments.............................38
Page
1
1.0 WARRANTY INFORMATION
Patton Electronics warrants all Model 1092ARC components to
be free from defects, and will-at our option-repair or replace the
product should it fail within one year from the first date of shipment.
This warranty is limited to defects in workmanship or materials, and
does not cover customer damage, abuse or unauthorized modification.
If this product fails or does not perform as warranted, your sole
recourse shall be repair or replacement as described above. Under no
condition shall Patton Electronics be liable for any damages incurred
by the use of this product. These damages include, but are not limited
to, the following: lost profits, lost savings and incidental or
consequential damages arising from the use of or inability to use this
product. Patton Electronics specifically disclaims all other warranties,
expressed or implied, and the installation or use of this product shall be
deemed an acceptance of these terms by the user.
1.1 RADIO AND TV INTERFERENCE
The Model 1092ARC generates and uses radio frequency energy,
and if not installed and used properly-that is, in strict accordance with
the manufacturer's instructions-may cause interference to radio and
television reception. The Model 1092ARC has been tested and found
to comply with the limits for a Class A computing device in accordance
with the specifications in Subpart J of Part 15 of FCC rules, which are
designed to provide reasonable protection from such interference in a
commercial installation. However, there is no guarantee that
interference will not occur in a particular installation. If the Model
1092ARC does cause interference to radio or television reception,
which can be determined by disconnecting the unit, the user is
encouraged to try to correct the interference by one or more of the
following measures: moving the computing equipment away from the
receiver, re-orienting the receiving antenna and/or plugging the
receiving equipment into a different AC outlet (such that the computing
equipment and receiver are on different branches). In the event the user
detects intermittent or continuous product malfunction due to nearby
high power transmitting radio frequency equipment, the user is strongly
advised to take the following steps: use only data cables with an
external outer shield bonded to a metal or metalized connector; and,
configure the rear card as shown in section 3.3 of this manual.
1.2 CE NOTICE
The CE symbol on your Patton Electronics equipment indicates
that it is in compliance with the Electromagnetic Compatibility (EMC)
directive and the Low Voltage Directive (LVD) of the European Union
(EU). A Certificate of Compliance is available by contacting Technical
Support.
2
Advertisement
Table of Contents
