Rts, Mate/Hub Wiring - Outback Power Systems FX AND VFX SERIES Installation Manual

RTS, MATE/HUB WIRING

����������
��������������
�����������������
�����������������
�������������
������������
��������
Battery Lights
LED Color
Green O
Yellow O
Red O
17
���������
Status Lights
LED Color LED Action
Green O Solid GREEN
Flashing GREEN
Off
Yellow O Solid YELLOW
Flashing YELLOW
Off
Red O Solid RED
Flashing RED
12 VDC
(FULL) 12.5 or higher
(OK) 11.5 to 12.5
(LOW) 11.5 or lower
RJ-11 modular jack connects RTS, the optional
external battery temperature sensor.*
RJ-45 jack connects MATE or HUB to FX using
CAT5 cable.**
*When a HUB is used, plug the RTS into the
Master FX, which should be plugged into
HUB's Port 01. The RTS cable is folded and
routed under the AC Wiring Compartment's
Lexan cover, fitting into a small indentation in
the aluminum casting between the battery
terminals. ONLY USE THE OUTBACK RTS; OTHER
BRANDS YIELD INCORRECT READINGS.
**If the system has multiple FXs and/or OutBack
Charge Controllers, a HUB is required.
LED Indicates
Inverter ON
Search Mode or Slave Power
Inverter OFF
AC Source is Connected
AC Input Live—Waiting to Connect to the FX
No AC Input Present
Error—An Error Message will be automatically displayed
on the MATE
Warning—A non-critical fault happened to the FX; the
MATE can access this info.
24 VDC
25.0 or higher
23.0 to 25.0
23.0 or lower
48 VDC
50.0 or higher
46.0 to 50.0
6.0 or lower