Mate Screens - Outback Power Systems GRID-INTERACTIVE GTFX Programing Manual

3. After powering up the components, connect the MATE to the HUB.
a) Plug the MATE into the 1st MATE Port on the HUB.
b) The MATE will power up and should recognize any component connected to the HUB.
c) The MATE can then program the FXs.
d) The fifth MATE screen ("Port Assignment") should display all the FXs and any Outback Charge Controllers in
the system.

MATE Screens

PATH
G' d ay Mate (C) 2004
OutBack
Power
Systems
4. To verify the MATE recognizes each HUB connected FX and OutBack Charge Controller, disconnect and then
either (a) reconnect the MATE to view its boot-up and repoll sequence or (b) follow this path to manually repoll:
PATH
MAIN------------------- SETUP-----------------
12.15:30p
choose device:
SUM STATUS SETUP ADV FX
The FXs are now ready to be programmed according to the stacking options described in the next
section.
Version Searching
Code a.aa for Devices
Serial #xxxxxxxx HUB Found
Screen EE b.bb
SETUP/MATE/PAGE1
mate code rev: 402
choose category:
MATE CLOCK CNT GLOW PG2
Port Assignment
1> FX 2> FX 3> CC 4> CC
5> 6> 7>
9> 10> 2M>
SETUP/MATE/PAGE2 SETUP/MATE/COMM
choose category: choose produce:
PG1 SUMRY COMM MAIN BACK REPOLL PC DEBUG
8>
8