Listening To The Radio - Sharp AN-PR1000H Operation Manual

Listening to the radio

AN-PR1000H
ON/
STAND-BY
Note:
This product can receive FM stereo/FM monaural broadcasts.
26
TUNER
SHIFT
Tuning
1
Press the ON/STAND-BY button to turn the power on.
2
Press the TUNER button repeatedly to select the desired
frequency band (FM Stereo/FM Mono).
3
Hold down the SHIFT button and press the (TUNING
ton to tune in to the desired station.
Manual tuning:
Press the (TUNING) button as many times as required to tune in to the desired
station.
Auto tuning:
When the (TUNING) button is pressed for more than 0.5 seconds, scanning will
start automatically and the tuner will stop at the first receivable broadcast station.
Notes:
When radio interference occurs, auto scan tuning may stop automatically at that
point.
Auto scan tuning will skip weak signal stations.
To stop the auto tuning, press the TUNING button again.
When an RDS (Radio Data System) station is tuned in, the frequency will be dis-
played first, and then the RDS indicator will light up. Finally, the station name will
appear.
Full auto tuning can be achieved for RDS stations "ASPM", see page 30.
To receive an FM stereo transmission:
Press the TUNER button to display the "STEREO" indicator.
" " will appear when an FM broadcast is in stereo.
If the FM reception is weak, press the TUNER button to extinguish the "STEREO"
indicator. The reception changes to monaural, and the sound becomes clearer.
06/3/14 06/3/14 AN-PR1000_EN.fm AN-PR1000_EN.fm
or ) but-
FM stereo mode indicator
FM stereo receiving indicator
TINSEA127AWZZ TINSEA127AWZZ