Timer And Sleep Operation - Sharp AN-PR1000H Operation Manual

Timer and sleep operation

AN-PR1000H
You can use the unit as an alarm clock by setting the timer.
Before setting timer:
1 Set the unit to the correct time (page 19).
If it is not set, you cannot use the timer function.
2 Prepare the sound source for playback.
3 Store radio stations (page 27)
SHIFT
32
Setting the timer
1
Turn the power on and hold down the SHIFT button and press the
TIMER button.
Set the unit to the correct time if "TIMER STANDBY" does not appear.
2
Within 10 seconds, hold down the SHIFT button and press the
button to select "TIMER SET", and press the ENTER button.
3
Hold down the SHIFT button and press the
the hour and then press the ENTER button.
4
Hold down the SHIFT button and press the
the minutes and then press the ENTER button.
The start time is set and the finish time (1 hour later) will be displayed
automatically.
5
Set the time to finish as in steps 3 and 4 above.
6
Switch input with the SHIFT and
or buttons, and then press
the SHIFT and ENTER buttons.
When you select the tuner, select a
station by pressing the SHIFT and
or buttons, and then press the
SHIFT and ENTER buttons.
If a station has not been
programmed, "NO P-SET" will be
displayed.
7
Adjust the volume with the SHIFT and
SHIFT and ENTER buttons.
Settings are displayed in order and the unit will enter the timer stand-by mode.
Caution:
This unit cannot set the timer of other equipment.
To perform the timer playback using other equipment, you should also
set the timer on the equipment separately.
06/3/14 06/3/14 AN-PR1000_EN.fm AN-PR1000_EN.fm
or
or button to adjust
or button to adjust
DIGITAL 1 DIGITAL 2 DIGITAL 3
TUNER LINE1
LINE3 LINE2
or buttons and press the
TINSEA127AWZZ TINSEA127AWZZ