Listening To The Radio - Sharp SD-AT100H Operation Manual

Listening to the radio

SD-AT100H
ENGLISH
[Front]
1
Press the ON/STAND-BY button to turn the power on.
2
Press the FUNCTION button to display FM or AM, and then the
BAND button repeatedly to select the desired frequency band (FM
STEREO, FM or AM).
When operating with the remote control, press the TUNER (BAND) button re-
peatedly to select the desired frequency band (FM STEREO, FM or AM).
E-25
3
Press the TUNING ( or ) button to tune in to the desired station.
Manual tuning:
Press the TUNING button as many times as required to tune in to the desired
station.
Auto tuning:
When the TUNING button is pressed for more than 0.5 seconds, scanning will
start automatically and the tuner will stop at the first receivable broadcast station.
Notes:
z This can be operated by pressing the
z When radio interference occurs, auto scan tuning may stop automatically at
that point.
z Auto scan tuning will skip weak signal stations.
z To stop the auto tuning, press the TUNING button again.
z When an RDS (Radio Data System) station is tuned in, the frequency will be
displayed first, and then the RDS indicator will light. Finally, the station name
will appear.
z Full auto tuning can be achieved for RDS stations "ASPM", see page 53.
To receive an FM stereo transmission:
Press the BAND button to display the "STEREO" indicator.
z "ST" will appear when an FM broadcast is in stereo.
FM stereo mode indicator
FM stereo receiving indicator
z If the FM reception is weak, press the BAND button to extinguish the "STEREO"
indicator. The reception changes to monaural, and the sound becomes clearer.
After use:
Press the ON/STAND-BY button to enter the power stand-by mode.
01/11/16 SD-AT100H(H)E3.fm
or button on the remote control.