Blowing Feature - Craftsman 125.16825 Operator's Manual

Operation (continued)
Blowing Feature
,_L WARNING:
,_ WARNING:
,_ WARNING:
Always wear safety goggles complying with ANSI Z87.1 (or in
Canada, CSAZ94.3) before using blower.
Keep bystanders clear from blowing debris.
Wear a dust mask if blowing creates dust that might be inhaled.
This Wet/Dry Vac has blowing capabilities.
To use the blower feature for cleanup
around the workshop, yard, patio and
other areas follow the instructions below.
1. Verify that the power cord is
disconnected from the outlet. (Fig. 1)
2. Make sure the collection tank is empty
before using as a blower.
3. Remove air/noise diffuser from blower
port. (Fig. 2)
4. Remove hose from vacuum port and
insert the locking end of the hose into
the blower port and lock into position.
(Fig. 3)
5. Fit the desired extension wand and or
nozzle to the free end of the vacuum
hose. (Fig. 4)
6.
7.
Ensure the power switch is in the "O"
OFF position. Plug into power supply.
(Fig. 5)
Before turning ON vac, firmly hold loose
end of the hose. Turn the unit on by
placing the power switch to the 'l' ON
position. (Fig. 6) For remote control_ use,
place the power switch to the "-'_'-"
Remote Control position, then press the
ON button located on the remote control
handle for at least one second.
10