Blowing Feature - Craftsman CMXEVBE179250 Instruction Manual

Blowing Feature (Fig. Z)
Your Vac features a Blowing Port. It can blow sawdust and
other debris. Follow the Steps below to use your Vac as a
Blower.
1. Locate Blowing Port (on Vac Motor Assembly - Top
Inlet) of your Vac.
2. Insert the Locking End of the "Pos-I-Lock®" Hose into the
Blowing Port of the Vac. The Hose should snap into place.
To remove the Hose from the Vac, press the Release
Button in the Hose Assembly and pull the Hose out of
the Vac Inlet Port.
3. (Optional) Attach Extension Wand to opposite end of
Hose, then place the Car Nozzle on the Wand.
4. Turn Vac on and you are ready to use your Vac as a
Blower.
SP7085-2 CMXEVBE179250.indb 15
WARNING:
!
Always wear safety eyewear complying with ANSI Z87.1
(or in Canada, CSA Z94.3) before using as a blower.
WARNING:
!
To reduce the risk of injury to bystanders, keep them
clear of blowing debris.
CAUTION:
!
Wear a dust mask if blowing creates dust which might
be inhaled.
CAUTION:
!
To reduce the risk of hearing damage, wear ear
protectors when using the Vac / Blower for an extended
time or in a noisy area.
Fig. Z
Hose Release Button
Hose Assembly
Vac Motor
Assembly
Blowing
Port
15
10/24/19 12:48 PM