Charging Assembly - Craftsman 973.113470 Operator's Manual

DRILL-DRIVER 973.113470
Chuck 318 in. Keyless
Motor DC Motor 12 Volt
Switch Variable Speed
No Load Speed 0-600 RPM
Clutch 24 Positions
Maximum Torque 100 in./Ibe
CHARGING ASSEMBLY
Rating
Charging Voltage
Charge Rate
BATTERY PACK
Item No. 9 11055
(1425004)
120 V, 60 Hz, AC only
12 Volt
3-6 Hours
Item No. 9 11056
(1323412)
KNOW YOUR DRILL-DRIVER
See Figure I.
Before attempting to use your drill-driver, familiarize
yourself with all operating features and safety
requirements.
KEYLESS CHUCK
Your drill-driverhas a keyless chuck that allows you to hand
tighten or release drillbit in the chuck jaws.
SWITCH
To turn your drill-driver ON, depress the switch trigger.
Release switch trigger to turn your drill-driver OFF.
SWITCH LOCK
The switch trigger can be locked in the OFF position. This
feature helps reduce the possibility of accidental starting
when not in use.
VARIABLE SPEED
Your drill has a variable speed switch that delivers higher
speed with increased trigger pressure. Speed is controlled
by the amount of switch trigger depression.s
FORWARD/REVERSE SELECTOR
(DIRECTION OF ROTATION SELECTOR)
Your drill-driver has a forward/reverse selector located
above the switch trigger.
WRIST STRAP
A wrist strap is provided to reduce the chances of dropping
your drill-driver. Place one hand through the wrist strap
when carrying tool.
BIT STORAGE
When not in use, bits provided with your drill-driver can be
placed in the storage area located on the bottom of the
motor housing.
LEVEL
To keep drill bit level during drilling operations, a level is
located on the back of the motor housing.
_1= WARNING: Do not allow familiarity with your drill-
driver to make you careless. Remember that a
careless fraction of a second is sufficient to inflict
severe injury.
_1_ WARNING: If any parts are missing, do not operate
your drill-driver untilthe missing parts are replaced.
Failure to do so could result in possible serious
personal injury.
7