To Install Battery Pack; To Remove Battery Pack - Craftsman 315.114852 Operator's Manual

CHARGING A HOT BATTERY PACK
When using the product continuously, the batteries in the
battery pack will become hot. You should let a hot bat-
tery pack cool down for approximately 30 minutes before
attempting to recharge. When the battery pack becomes
discharged and is hot, this will cause the green LED to
come on instead of the red LED. After 30 minutes, reinsert
the battery pack in the charger. If the green LED continues
to remain on, return battery pack to your nearest Sears or
other qualified service center for checking or replacing.
NOTE: This situation only occurs when continuous use of
the product causes the batteries to become hot. It does
not occur under normal circumstances. Refer to CHARG-
ING A COOL BATTERY PACK for normal recharging
of batteries. If the charger does not charge your battery
pack under normal circumstances, return both the battery
pack and charger to your nearest Sears or other qualified
service center for electrical check.
BATTERYPACK
SHOWNIN CHARGER
CHARGER
RED LED
TO iNSTALL BATTERY PACK
See Figure 3.
[] Lock switch trigger on the drill by placing the direction
of rotation selector in center position.
[] Place battery pack in the drill. Align raised rib on bat-
tery pack with groove inside drill.
[] Make sure the latches on each side of your battery
pack snap in place and battery pack is secured in drill
before beginning operation.
CAUTION: When placing battery pack in the drill, be
sure raised rib on battery pack aligns with groove in-
side drill and latches snap into place properly. Improper
assembly of battery pack can cause damage to internal
components.
A
WARNING: Always remove battery pack from your
tool when you are assembling parts, making adjust-
ments, cleaning, or when not in use. Removing bat-
tery pack will prevent accidental starting that could
cause serious personal injury.
TO REMOVE BATTERY PACK
See Figure 3.
[] Lock switch trigger on the drill by placing the direction of
rotation selector in center position.
[] Locate latches on side of battery pack and depress to
release battery pack from the drill.
[] Remove battery pack from the drill.
GREENLED
[
YELLOW
LED Fig. 2
CAUTION
Do not use any DC to AC power
inverters, Charger will be Damaged!
i
BATTERY
PACK
LATCHES
12
DEPRESS LATCHES TO
RELEASE BATTERY PACK
Fig. 3