Advertisement
Available languages
Available languages
TORQUE
ADJUSTMENT
KEYLESS
RING
CHUCK
SWITCH
TRIGGER
SCREWDRIVER
BITS
BATTERY
PACK
WRIST
STRAP
BATTERYPACKSHOWN
IN CHARGING STAND
RED LIGHT
(LED)
CHARGING
STAND
CHARGER
\
DIRECTION
OF ROTATION
SELECTOR
(FORWARD
REVERSE)
LEVEL
BATTERY PACK
BIT
STORAGE
8
Fig. 1
The battery pack for your tool has been shipped in a low
charge condition to prevent possible problems. Therefore,
you should charge it overnight prior to use.
Note: Batteries will not reach full charge the first time they
are charged. Allow several cycles (drilling followed by
recharging) for them to become fully charged.
CHARGING BATTERY PACK
Gee Figure 1.
•
Charge battery pack only with the charging assembly
provided.
•
Make sure power supply is normal household
voltage, 120 volts, 60 Hz, AC only.
•
Connect charger to power supply.
•
Place battery pack in charging stand. Align raised rib
on battery pack with groove in charging stand.
See FigureI.
•
Press down on battery p ack to be surecontacts on
battery p ack engage properly withcontacts incharging
stand.
•
The charge indicator light (LED), located on the
charging stand, will light up red and glow when the
charger is properly connected to power supply. This
light indicates the charger is operating properly. It will
remain on until battery pack is removed from charging
stand or charger is disconnected from power supply.
The light only glows while battery pack is charging.
•
Note: If charger does not charge battery pack, return
battery pack and charging assembly to your nearest
Sears Repair Center for electrical check.
•
After normal usage, 3 hours or less of charging time is
required to fully recharge battery pack. Note: If battery
pack is completely discharged, 6 hours or longer of
charging time is required to fully recharge battery
pack.
•
The battery pack will become slightly warm to the
touch while charging. This is normal and does not
indicate a problem.
•
Do not place charger in an area of extreme heat or
cold. It will work best at normal room temperature.
•
When batteries become fully charged, unplug charger
from power supply and remove the battery pack.
IMPORTANT
INFORMATION
FOR RECHARGING
HOT BAI-FERIES
When using your drill-driver continuously, the batteries in
your battery pack will become hot. You should let a hot
battery pack cool down for approximately 30 minutes
before attempting to recharge.
Note: This situation only occurs when continuous use of
your drill causes the batteries to become hot. It does not
occur under normal circumstances. Refer to "CHARGING
BA'rrERY PACK" for normal recharging of batteries. If the
charger does not charge your battery pack under normal
circumstances, return both the battery pack and charger to
your nearest Sears repair center for electrical check.
Advertisement
