GE GTH15BBRFLCC Owner's Manual And Installation Instructions page 24

Installation Instructions
IRII REVERSING THE DOOR SWING (CONT.)
[]REHANGING THE DOORS
6.1 Rehang the fresh food door
6.1.1 Lower the fresh tood door onto the
bottom hinge pin. Be sure the washer
is in place on the pin.
6
Washer
8racket
Models with a hingebracket
that has 2 screw holes.
/
Plastic
Washer
8racket
Modelswith a hingebracket
that has4 screw holes.
[] REHANGING THE DOORS (CONT.)
6.2 Rehang the freezer door
6.2.1 Lower the freezer door onto the center
hinge pin. Be sure the washer and
spacer are in place on the pin.
CeeterHingePin
her
andSpacer
6.1.2 Insert the pin on the center hinge into the
socket in the top of the doo_: Place the spacm;
then the ,a-ashm; on the hinge pin.
NOTE: The center hinge must be turned over
as shown when mounted on the left side.
HingePin
andSpacer
6.1.3 Tilt the door toward the cabinet. As the door is
brought into position, slide the hinge under the
head of the screw which earlier had been partly
driven into the outermost hole. Insert the
remaining screw, then tighten both screws
securely.
6.2.2 Tilt the door toward the cabinet, lilting the top
hinge so the pin fits into the socket on the top
of the door.
6.2.3. Make sure the door is slightly above the top of
the cabinet and the gap between the doors is
even across the fi'ont. Tighten the top hinge
screws. Do not overtighten these screws-tighten
them until they are just snug, then turn them
another one-half turn.
24