Installing The Table; Clamping Band Saw To Workbench - Craftsman 113.244510 Owner's Manual

assembly
2. Securely clamp board to workbench
"C" clamps.
using
NOTE: Supporting surface where band saw is
mounted should be examined carefully after
mounting to insure that no movement during use
can result. If any tipping or walking is noted
secure workbench or supporting surface before
operating band saw.
CLAMPING BANDSAW TO WORKBENCH
,,0 _,
CLAMP
The Band Saw can be clamped directly to a
workbench using two (2) or more "C" clamps on
base of unit.
C
CLAMP
WORKBENCH
INSTALLING THE TABLE
Apply a coat of automobile wax to the table top
and inside surfaces of trunnion that slide on
frame.
1.
.
,
Loosen the guide bar lock knob and position
the upper guide assembly all of the way up.
Tighten lock knob.
Locate two (2) knobs and two (2) 17/64 x
47/64 x 1/16 washers in loose parts bag, and
the table assembly in loose parts.
Place table assembly onto band saw frame
with the trunnion against mounting rib in
frame.
TABLE
ASSEMBLY
TRUNNION
SLOTS
4.
Hold table assembly against the frame and
install two (2) table lock knobs and washers
as shown through the trunnion slots and
tighten,
TABLE LOCK
KNOBS
\