Assembly; Installing The Table - Craftsman 113.244580 Owner's Manual

Assembly
WARNING: For your own safety, never connect
plug to power source outlet until all assembly
steps are complete, and you have read and under-
stood the safety and operational instructions.
From the
Item No.
A
B
C
D
E
F
G
H
J
K
L
M
loose parts find the following items:
Description Qty
1/4-20 x 7/8" Flat head screws ...................... 3
1/4-20 Hex nuts ............................................. 3
1/4 Lockwasher ............................................. 3
1/4-20 x 3/4 Truss head screw ....................... 1
1/4-20 Wing nut ............................................. 1
1/4 Washer .................................................... 1
Switch Key ..................................................... 1
1/8" He× "L" Wrench ...................................... 1
3/16-24 x 3/8 Screw ....................................... 1
Indicator ......................................................... 1
Table w/Insert (not pictured) .......................... 1
Sawblade (not pictured) ................................. 1
D
G
H
Installing the Table
Get table from among loose parts.
1. Place table with insert onto trunnion and align holes in
the table to those in the trunnion. Use the three 1/4-20
fiat head screws, three 1/4 Iockwashers and the three
1/4-20 he× nuts to secure table. Tighten nuts with an
open end or an adjustable wrench.
2. Loosen the table lock knob and turn the table tilt knob
to change the angle of the table. If the table is loose or
too tight, adjust the hex head bolt with an open end or
an adjustable wrench until firm, smooth table tilt opera-
tion is achieved.
"Hex Head
Bolt
Table
Knob
3. Assemble the bevel indicator to the saw frame using
the 3/16-24 x 3/8 screw.
Bevel
Indicator