Table of Contents
Advertisement
INSTALLING THE EXTENSION TABLE (FIG. G)
Fig. H
[,_
WARNING
1
To avoid injury or possible damage to the tool, support
long work pieces by installingthe extension table to
extend the work support surface.
IA WARNING
I
When using extension and stop block on the right side,
hold down clamp must also be in right side. Using hold
down clamp on the left side during this operation can
cause kick-back and serious injury to the operator.
NOTE: The extension table is assembled at the factory to
be installed on the left side of the saw. If you wish to
attach the extension table on the right side, please skip
to page 14, Adjusting Extension Table Figure O.
1. Place the table extension rods into the two holes (1)
provided in the miter saw base.
2. Insert one Phillips head screw (2) into the hole (3) and
tighten to hold the extension table.
3. Loosen the locking knob (4), slide the stop block
assembly (5) to the desired location, re-tighten the
locking knob (4).
Fig. G
2
3
5
4
7. Locate the arbor lock (5) on the motor, below the
miter saw switch handle. (Fig. I)
8. Press the arbor lock, holding it in firmly while turning
the blade wrench clockwise. The arbor lock will then
engage and lock the arbor. Continue to hold
the arbor lock, while turning the wrench clockwise to
loosen the arbor bolt.
Fig. I
REMOVING OR INSTALLING THE BLADE
['_
WARNING
I
1. Only use a 10-inch diameter blade.
2. To avoid injury from an accidental start, make sure the
switch is in the OFF position and plug is not connected to
the power source outlet.
REMOVING (Fig. H, I, J)
IA WARNING
I
1. Unplug the saw from the outlet.
2. Raise the miter saw to its' upright position,
3. Raise the lower clear plastic blade guard (1) to the
updght position. (Fig. H)
4, Loosen the cover plate screw (2) with a Phillips
screwdriver.
5. Rotate the cover plate (3) to expose the arbor bolt
(4).
6. Place the blade end wrench over the arbor bolt.
_
I1, .
rJ" I!'!
12
5
IIII
Hide quick links:
Advertisement
Table of Contents
