Table of Contents
Advertisement
basic drill press operation
WARNING:
TO avoid injury from spinning work or
tool breakage, always clamp workpiece and back-
up material securely to table before operating Drill
Press with the table tilted.
To return table to original position: Ioosen set screw
and bevet lock, tilt table back to 0 ° on bevel scale, and
retighten set screw - then tighten bevel lock.
HOLE LOCATION
Make a DENT in the workpiece where you want the
hole..,
using a CENTER PUNCH or a SHARP NAIL.
Before
turning the switch ON, bring the drill down to
the workpiece lining it up with the hole location.
FEEDING
Pull down on the feed handles with only enough effort
to allow the drill to cut.
Feeding
TOO SLOWLY might cause the drill to burn.
• Feeding TOO RAPIDLY might stop the motor...
cause
the belt or drill to SLIP .
. tear the workpiece
LOOSE
or BREAK the drill bit.
adjustments
WARNING:
For your own safety turn switch "OFF"
and remove plug from power source outlet before
making
any adjustments.
To avoid injury from
thrown parts due to spring release, follow instruc-
tions carefully.
QUILL RETURN SPRING
1. Move the stop nuts and depth pointer to lowest pos-
ition and lock in place with wrench to prevent quill
dropping while tensioning spring.
2. Lower table for additional clearance.
3. Work from left side of Drill Press.
4. Place screwdriver in lower front notch of spring cap,
and hold it in place while loosening and removing
jam [outer] nut only.
5. With screwdriver remaining in notch, loosen large
standard [inner] nut (approximately 1/8") until notch
disengages from boss on head. DO NOT REMOVE
THIS NUT.
6. Carefully turn screwdriver counter clockwise and en-
gage
next notch
in boss.
DO NOT REMOVE
SCREWDRIVER.
7. Tighten standard nut with wrench only enough to
engage boss. Do not overtighten as this will restrict
quill movement.
8. Move stop nuts and depth pointer to upper most
position and check tension while turning feed han-
dles.
9. if there is not enough tension on spring, repeat steps
4-8 moving only ONE notch each time and checking
tension after EACH repetition.
10. Proper tension is achieved when quill returns gently
to fuji up position when released from 3/4" depth•
11. When there is enough tension after checking, re-
place jam nut and tighten to standard nut, BUT do
not overtighten against standard nut.
I
NOTCH
BOSS
JAM
NUT
(OUTER)
STANDARD
NUT
I
(INNER)
\
\
\
NOTCH
12.
Check quill while feeding to have smooth
and un-
restricted
movement.
If movement
is too tight,
loosen jam nut and SLIGHTLY
loosen
standard
nut until unrestricted. Retighten jam nut.
20
Hide quick links:
Advertisement
Table of Contents
