Craftsman 113.19761 Owner's Manual page 13

2.
Loosen (2) ¼ - 20 Gib set screws on the left side at the
rear of the column support.
->
3. Elevate, and then lower the Arm: (a) if the column
binds and elevation is difficult loosen two 5/16- 18
plated nuts on front side of the column support until
you achieve smooth but firm elevation. (b) If the
column moves side-to-side within the column support,
tighten the two 5/16 - 18 plated nuts until movement
disappears -- elevation should be smooth and firm.
4. Now tighten the (2) ¼ - 20 Gib set screws until no
noticeable rotational play exists between Column Tube
and Column Support.
5. Recheck elevation and re-adjust if necessary.
8R,O.T LA,Eo<JT
BOLTS \ I
©
L
T-
_I
STEP THREE
SQUARING CROSS CUT TRAVEL (CARRIAGE
TRAVELS IN A STRAIGHT LINE).
1. Index but do not lock arm at 0 ° miter.
2. Install saw blade as shown. Motor shaft has left hand
threads.
_,:_ ° END OF ARBOR WRENCH
%/ RESTING ON TABLE
MOTOR SPACER
SAW BLADE
)IOR
SHAFT NUT
ER COLLAR