Advertisement
STEP 19: (SEE FIGURE 19)
Only for mower decks smaller than 54"
•
Attach the rear of the clutch/idler assembly to the tractor
frame by sliding the notched arms of the assembly onto
the shoulder bolts assembled to the frame brackets.
Lift the front of the assembly, positioning the upper idler
pulley so that it clears the engine pulley. Attach the front
of the assembly to the hanger brackets using two pivot
lock pins (MM) and two hairpin cotters (KK).
......... PIVOT LOCK PiN (MM)
FIGURE 19
STEP 20: (SEE FIGURE 20)
Only for 54" mower decks
•
Attach the rear of the clutch/idler assembly to the tractor
frame by sliding the notched arms of the assembly onto
the shoulder bolts assembled to the frame brackets.
Lift the front of the assembly, positioning the upper idler
pulley so that it clears the engine pulley. Attach the front
of the assembly to the hanger brackets using two pivot
lock pins (MM) and two hairpin cotters (KK).
54" MOWER DECKS
.............................PIVOT LOCK PiN (MM)
COMPLETE
STEPS #47 THRU #59 iN THE
SNOW THROWER
MANUAL, THEN RETURN
TO STEP 21 ON THiS PAGE.
STEP 21: (SEE FIGURE 21)
•
Loosen the two hex bolts and nuts which fasten the top
of the tractor drawbar to the rear of the tractor frame.
Assemble the notched end of the side brace arms
down onto both loosened bolts. Do not tighten yet.
Fasten the weight tray to the drawbar using a
1/2" x 1-1/4" hex bolt (A), a 1/2" washer (V) and a 1/2"
nylock nut (EE). Do not tighten yet.
Fasten the weight tray to the side brace arms using
two 5/16"x
1" carriage bolts (N) and two 5/16" nylock
nuts (CC). Do not tighten yet.
Fasten the cross brace to the side brace arms using
two 5/16"x 1" carriage bolts (N) and two 5/16" nylock
nuts (CC). Tighten all loose bolts at this time.
/'
1/2" x 1-1/4"
HEX BOLT (A)
/
/
i
CROSS
LOOSENED
BRACE
NUT AND BOLT
/
/
5/16" x 1"
CARRIAGE
BOLT (N)
SIDE BRACE
ARM
5/16" NYLOCK
(_
NUT (CC)
WEIGHTTRAY
1/2" WASHER (V)
1/2" NYLOCK NUT (EE)
FIGURE 21
VIEWED FROM REAR
RETURN TO STEP #64 iN THE SNOW
THROWER
MANUAL
AND FiNiSH
ASSEMBLING
THE SNOW THROWER.
FIGURE 20
Call 1-866-576-8388
for missing parts or assembly help
DO NOT RETURN TO STORE
Advertisement
