Advertisement
STEP 16:
@
@
(SEE FIGURE 16)
Turn the clutch/idler assembly upside down.
Hook the end of the spring (GG) onto the bottom of the
bolt and nut which secure the idler pulley to the upper
idler arm. Hold the bolt head and assemble a 3/8" hex
lock nut (DD) onto the bolt, leaving enough space for
the spring to pivot freely between the two nuts.
SPRING (GG)
3/8" HEX
LOCK NUT
(DD)
UPPER
iDLER
ARM
\
•
FIGURE 16
VIEWED FROM BOTTOM
STEP 18: (SEE FIGURE 18)
*
Two different length drive belts are supplied with your
snow thrower. Select the shorter belt with #46989
printed on it.
*
Slightly loosen the hex bolt next to the upper idler
pulley. Install the drive belt down between the hex bolt
and the upper idler pulley with the fiat side of the belt
against the pulley. Retighten the hex bolt.
*
Loop the belt around the large v-pulley, placing it
between the v-pulley and the hex bolt next to the pulley.
HEX BOLTS
UPPER iDLER
PULLEY
/
DRIVE
BELT
#46989
FIGURE 18
STEP17:
@
@
(SEE FIGURE 17)
Turn the clutch/idler assembly right side up.
insert the tensioning chains through the holes shown
on the left and right sides. Attach the ends of the chains
to the springs on the upper and lower idler arms.
install a 3/32" hairpin cotter (LL) into the left side
chain. If the tractor's engine pulley is smaller than 6",
place it in link #3 from the spring. For larger engine
pulleys, place it in link #6 from the spring.
3/32" HAiRPiN
COTTER (LL)
iN LiNK #3 or #6
/
LEFT & RIGHT
TENSiONiNG
CHAINS (PP)
FIGURE 17
6
Call 1-866-576-8388
for missing parts or assembly help
DO NOT RETURN TO STORE
Advertisement
