Table of Contents
Advertisement
Cocking the Quick Release Chuck
The quick release chuck must be cocked in order to install a bit. To cock
the chuck, press all the way up on the chuck release flange (See Figure
25) and release.
The outer flange will snap up when the chuck is
prepared
to receive the bit assembly.
Any time difficulty
is encountered
inserting
a bit and adapter simply pull up on the flange to insure the chuck
is cocked.
Bit Assembly
Installation
When a carving function
has been selected from the display menu, the
CompuCarve
will move the cutting head to the center of the machine
and
prompt for the required
bit.
Quick
Release
Chuck
FIGURE24:
QUICK RELEASE
CHUCK
To insert a bit: lift up on the front safety cover, cock the quick release
chuck, and press the bit assembly
into the chuck until a slight snap is felt.
Close the cover and press the ENTER key. The machine will proceed
with measuring
the bit and processing
the selected
task.
Be certain to insert only the proper bit requested;
damage to
the workpiece
and/or damage to the CompuCarve
machine
may result from
installing
incorrect
cutting
bits.
All motors are disabled whenever
the cover is open.
The cover
must be closed before the machine can proceed.
Sears, Roebuck and Co.
CompuCarve
TM
System (Rev 1.6) 09/27/06
Page 29
Advertisement
Table of Contents
