Bit Adapter - Craftsman CompuCarve 183.217540 Operator's Manual

Compucarve system
Table of Contents

Advertisement

Bit Adapter Assembly
The CompuCarve
utilizes a patented
quick release chuck system to make
changing
bits fast and easy.
To use this system the bits must first be
installed
into the bit adaptors.
For 1/2" shank
bits, insert threaded
bit adaptor
into the chuck assembly
and then insert bit into threaded
collet (See Figure 20) and tighten the
collet with a wrench.
Position the bit in the adapter as shown in Figure 22.
Verify that the collet is also securely
tightened.
For 1/4" shank
bits, insert bit into bit adapter and tighten setscrews
with
supplied
Allen wrench (See Figure 21).
Position the bit in the adapter as
shown in Figure 22 and always make sure the setscrews
are tight.
For
long-term
bit setup use a drop of permanent
thread cement on the
setscrews.
//_
WARNING:
Failure to correctly
install
the bit in the adapter
can result in injury, damage to the machine,
or damage to the
workpiece.
j
Bit Adapter
FIGURE20:
COLLET ARRANGEMENT
FOR1/2"
SHANK BITS
FIGURE21:
COLLET ARRANGEMENT
FOR
1/4"
SHANK BITS
Sears, Roebuck and Co.
CompuCarve
TM
System (Rev 1.6) 09/27/06
Page 27

Advertisement

Table of Contents
loading

Table of Contents