Craftsman 171.240300 Owner's Manual page 8

FIGURE 9
Slide HeX Nut Into
Hex Nut Slot Align
with Through Hole
Bottom Carriage Round
Bolt Slot Knobs
11. Slide one (1) #10xl" carriage bolt into the top
carriage bolt slot on the front of the aluminum guide
and install the stop piece, #10 washer, and three
wing knob as shown in Fig. 10.
FIGURE 10
Aluminum Guide Top Front Carriage
Bolt Slot
#10 Washer
FIGURE 11
Three Wing
Stop Piece
Hex Nut Slot
Stop place
Aluminum Guide
Extension Bar
12. Slide the long extension bar sub-assembly into
the.aluminum guide as shown in Fig. 11. Slide the..._
bar into the extrusion u ntil t heend cap isincontact
withthealuminum guideend,
i i
I NOTE I The end caps and extension bars
are interchangeable ineither end ofthe miter barfor
use on either sideofsaw blade. Reorienting e xten-.
sion bar and end caps will be necessary.
13. Repeat step 12 for the short extension bar.
14. Attach the guide to your miter gauge using the
two carriage bolts on the back of the aluminum
guide, two (2) #10 washers, and two (2) three wing
knobs as shown in Fig. 12.
FIGURE 12-
#10 x 1" Carriage Bolts
In Cardage Bolt Slot
i -
Bottom Carriage
Bolt Slot
lashers
Parts Removed from
Miter Gauge for Clarity
Three Wine
Knobs
15. The miter guide should now be fully assembled
and be ready for use on your table saw. Refer to Fig.
13 for a fully assembled view.
FIGURE 13
BLADE GUARD NOT SHOWN FOR CLARITY
lyp. Table Saw Top
(Extensions NOt
Shown For Clarity)
8