Craftsman 171.240300 Owner's Manual page 16

WARN' GI
The thickness of the back-up.
board cannot exceed 1/8" thickness.
I NOTE I The back-up board should not be
installed on the unit until the box joint setup steps
have been completed and you are ready to cut fin-
ished boards.
1. Obtain two pieces of suitable material and cut
both pieces so that one piece is 13" wide x 3 1/2" tall
and the second piece is 5" wide x 3 1/2" tall. Position
the long (infeed) back-up board on the unit as shown
in Fig. 29 and cut one slot.
FIGURE-29
2. Remove the infeed board from the unit and place
double-stick tape on the back of the board, being
careful to avoid placing the tape where it could con-
tact the product/warning label on the guide.
3. Place the infeed board on the unit as shown in
Fig. 30, making sure that the board is attached to
the unit securely.
4. Repeat steps 2 and 3 for the short (outfeed) back-
up board and locate on the unit as shown in Fig. 30.
FIGURE 30
Mount Outfeed
Back-Up Board
16