Assembly; Tools Included - Craftsman 171.240300 Owner's Manual

TOOLSlNCLUDED
• Mini-driver, 3/8" nut driver and P2 Phillips insert bit
SEE PARTS LIST FOR EXPLODED VIEW OF
TABLE SAW BOX JOINT AND MITER GUIDE
1. Carefully unpack components from carton and
confirm that all parts have been shipped with the
product (refer to the parts list on page 15 of instruc-
tion manual to identify the components).
2. Locate the main guide and slide four (4) of the
#10xl 3/8" carriage bolts into the carriage bolt slot
and space apart as shown in Fig. 1.
FIGURE 1
I #10 x 1 - 3/8" Carriage Bolt J
7
/
Product/Warning Label
3. Place the left lower guide over two (2) of the car-
riage bolts as shown in Fig. 2. Confirm that the hash
marks on the lower left guide and the product/warn-
ing label are facing in the same direction as shown
in Fig. 2.
FIGURE2
JlO x 1 - 3/8" Carriage BoR
Aluminum Guide
Left Lower Guide
4. Assemble the left slide piece to the left lower
guide as shown in Fig. 3.
FIGURE 3
#10 Flex Nut
#10 Washer
Left Slide #10 Hex Nut
#10Washer
Aluminum Guide
Left Lower Guide
5. Install the #10 washers and hex nuts on the two
carriage bolts making sure to thread the hex nuts so
the left lower guide and the left slide piece can be
adjusted side-to-side during the assembly steps.
6. Attach the fixed tab and adjustable tab to the right
slide piece using the #10 hex nut and the #10x3/8"
pan head screw. Refer to Fig. 4 for the correct orien-
tation of the tabs and for the placement of the hex
nut.
FIGURE4
Right Sllde
Drop Hex Nut
Into Slot
Fixed Tab
AdJustobleTab
_nH_d _rew