Craftsman 171.240300 Owner's Manual page 4

16. Dlecortnect tools .... 21. Direction of feed
Before servicing, when.chan_] n_j"a_ries such ,'- _ Feed W0rk ,into a bl_db!0r cuttbr only against the
as blades, bits, cutters, etc.
17. Avoid accidental starting
Make sure switch is in "OFF" position before
plugging in.
lB. Use recommended accessories
Consult the owner's manual for recommended
accessories and follow the instructions. The use of
improper accessories may cause hazards.
19. Never stand on tool
Serious injury could occur if the tool is tipped or
if the cutting tool is accidentally contacted. Do not
store materials above or near the tool making it
necessary to stand on the tool to reach them.
20. Check damaged parts
Before further use of the tool, any guard or other part
that is damaged should be carefully checked to
ensure that it will operate properly and perform its
intended function. Check for alignment of moving
parts, binding of moving parts, breakage of parts,
mounting, and any other conditions that may affect
its operation. A guard or any other part that is dam-
aged should be properly repaired or replaced.
direction of rotation of the blade or cutter.
22. Never leave tool running unattended
Turn power off. Do not leave tool until it comes to a
complete stop.
23. Keep hands away from cutting area
24. Store idle tools
When not in use, tools should be stored in dry, high
or locked-up place - out of reach of.children.
25. Do not abuse cord
Keep cord away from heat, oil and sharp edges.
26. Outdoor extension cords
When tool is used outdoors, use only extension
cords suitable for use outdoors and so marked.
27. Never use in an explosive atmosphere
Normal sparking of the motor couldignite fumes,
flammable liquids, or combustible items.
28. Drugs, alcohol, medication :
Do not operate tool while under the influence of
drugs, alcohol, or any medication.
Read and Understand this instruction book
completely BEFORE using this product.
1. Always wear eye protection that complies with
current ANSI Standard Z87.1.
2. Noise levels vary widely. To avoid possible hear-
ing damage, wear ear plugs or muffs when using the
Table Saw Box Joint and Miter Guide.
3. Wear a dust mask along with the safety goggles.
4. Follow the instructions in your table saw owner's
manual.
5. Do not use this product until all assembly installa-
tion steps have been completed, and you have read
and understand all safety and operational instruc-
tions in this manual.
6. This product is designed to cut flat workpieces.
Do not out or attempt to cut workpieces that are
. not flat or that are irregularly shaped.
7. This product is to be used for cutting wood work-
pieces only. Do not use this product to cut metal.
ILJmWARNING
I Always UNPLUG the table saw
from the electrical outlet:
• before installing or removing saw blades from the
table saw
• when adjusting the cutting depth or width of the
saw blade or dado blade
• when changing the setup of the Box Joint and
miter guide.
8. Making box joint cuts requires the unit to pass
over the saw blade. Remember to keep your hands
away from the cutting area.
9. When setting up to make test cuts using the box
joint unit, confirm that the saw blade or dado blade
does not contact the fixture.
10. Confirm that all fasteners remain tight and
secure through all operations:
4