Craftsman 171.240300 Owner's Manual page 13

2; Select the long board and short board with the =A"
comer. Place the,long board on:the support ledge as
shown in Fig. 23B, Cut the first slot making sure to
keep the leading edge of the workpiece against the
adjustment tab, against the back of the guide and
against the top of the support ledge.
FIGURE 23B
Locate Edge Against
Adjustable Tab
Letter "A" Facing Out
Support
Ledge
FIGURE:23D
Flip Board SoThst "A"
Side Is Facing Guide
Long Board
Keep Leading Edge of
Short Board Agelnst
Long Board
OF FEED Facing Guide
DIRECTION .
OF FEED
3. Reposition the long board as shown in Fig. 23C
so that the slot cut in step 2 is located over the
adjustable and fixed tabs. Cut the second slot as in
step 2.
FIGURE 23C
Slip First Cut Over Fixed
and Adjustable Tabs
A
DIRECTION
OF FEED
4. Repeat step 3 until the long side is completed.
5. Reorient the long board on the support ledge as
shown in Fig. 23D such that the =A" marking is fac-
ing towards the guide.
6. Place the short board on the support ledge as
shown in Fig. 23D such that the "A" marking is fac-
ing towards the guide.
7. While holding both boards firmly in place, cut the
first slot. Remove the long board from the unit and
reposition: the short board as shown in Fig. 23E. Cut
the rest of the slots as described in step 3 & 4.
FIGURE 23E
Keep Slot Edge
Against AdjustableTab
8. Repeat steps 2 - 7 for the "C" corner.
9. Select the long board and short board with the "B"
corner. Place the long board on the fixture as shown
in Fig. 24A. Cut the first slot making sure to keep the
leading edge of the workpiece against the adjust-
ment tab, against the back of the guide and down
against the top of the support ledge.
FIGURE 24A
Locate Edge Against
Adjustable Tab
Letter "B" Facing Guide
13