Frigidaire FES365ESE Use & Care Manual page 11

Drop-in/ slide-in models
Hide thumbs Also See for FES365ESE:
Table of Contents

Advertisement

so,.,., s.,.o
Models
with
Ceramic
Glass
Cooktop
o
(continued)
Small
El ement
Operating
the Dual Surface
Radiant
Element
Figure
1
(Models
with Ceramic
Glass Cooktop
Only)
Sma,
Large
Model A is equipped with Dual radiant surface elements at all
Pe_,
OFF
G,ood
o hi
hi @
positions (See Figure 8). Models B & C are equipped with a
dual radiant surface element located at the right front (See
6
Figures 9 & 10) position. Symbols on the control panel are
used to indicate which coil of the dual radiant element will heat.
The O symbol indicates that only the inner coil will heat
and 5). The 1_ symbol indicates that both inner
(Figures 1, 3,4
and outer coils will heat (Figures 6, 8, 9 and 10). You may
switch from either coil setting at any time during cooking.
To Operate
the Dual
Surface
Element:
1.
Place correctly
sized cookware
on the dual surface
element.
2.
Push in and turn the control knob counterclockwise
(See
Figu re 2) for smaller cookware or clockwise (See Figure 7)
forlarger cookware.
3.
Turn the knob to adjust the setting if needed. Start most
cooking operations on a higher setting and then turn to a
lower setting to finish cooking.
Each surface element
provides a constant amount of heat at each setting. A
glowing red surface heating area extending beyond the
bottom edge of the cookware indicates the cookware is
too small for the surface heating area.
4.
When cooking has completed, turn the surface control
knob to OFF before removing the cookware. Note: The
Surface indicator light will come on when the control knob
will be turn on and will continue to glow until the glass
cooktop has cooled down to a moderate level. The light
may remain on even though the controls are turned OFF.
Note: See page 9, Figure 1 for recommended control settings.
Radiant surface elements mayappear to have
cooled after they have been turned off. A hot surface indicator
light will come on and will continue to glow until the glass
cooktop has cooled down to a moderate level. The glass
surface
may still be hot and burns may occur if the glass
surface is touched before the indicator light has turned off.
o
o
o o
Figure 3 - Model A
ooo
Figure 4 -Model B
©
Figure 5 -Model C
@
Large
Element
Figure 6
Small
Peril
OFF
o hi
,,_,_,,, ,, . ..... hi @
6
_f
4
2
©
o
1o
1o
@ ®
Figure 7
o
o
Figure 8 - Model A
o
o
o
o
Figure 9 - Model B
0
oo
o o
Figure 10 - Model C
11

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents