Advertisement
_IL
WARNING:
Your drill should never be
connected to power supply when you are
assembling parts, making adjustments,
installing
or removing drill bits, cleaning, or when not in
use. Disconnecting
your drill will prevent
accidental starting that could cause serious
personal injury.
SWITCH
See Figure 2.
To turn your drill ON, depress the switch trigger.
Release switch trigger to turn your drill OFF.
MODELS 315.101211
AND 315.101221
LOCK-ON
BUTTON
SWITCH
TRIGGER
MODEL 315.101231
Fig. 2
LOCK-ON
BUTTON
See Figure 2.
Your drill is equipped with a lock-on feature, which is
convenient when continuous drilling for extended
periods of time is required. To lock-on, depress the
switch trigger, push in and hold the lock-on button
located on the side of the handle, then release switch
trigger. Release lock-on button and your drill will
continue running.
To release the lock, depress the switch trigger and
release.
If you have the lock-on feature engaged during use
and your drill becomes disconnected from power
supply, disengage the lock-on feature immediately.
_
WARNING:
Before connecting your drill to
power supply source, always check to be sure it
is not in lock-on position (depress and release
switch trigger). Failure to do so could result in
accidental starting of your drill resulting in
possible serious injury. Also, do not lock the
trigger on jobs where your drill may need to be
stopped suddenly.
REVERSIBLE
See Figure 3.
Your drill has the feature of being reversible. The
direction of chuck rotation is controlled by a lever
located above the switch trigger. With your drill held in
normal operating position, the direction of rotation lever
should be positioned to the left of the switch for
forward drilling operation. The direction of rotation is in
reverse when the lever is to the right of the switch.
The design of the switch will not permit changing the
direction of rotation while the drill is running. Release
the switch trigger and allow the drill to stop before
changing its direction.
Note: Your drill will not run unless the switch lever is
pushed fully to the left or right.
MODELS 315.101211
AND 315.101221
FORWARD
REVERSE
FORWARD,
REVERSELEVER
MODEL 315.101231
Fig. 3
VARIABLE
SPEED
(Model
101221)
See Figure 4.
If you have this model, your drill has a variable speed
switch designed to allow operator control and adjust-
ment of speed and torque limits. The speed and
torque of your drill can be increased or decreased by
depressing the switch trigger.
Note: Depress switch trigger all the way for maximum
speed and torque of your drill. Depress switch trigger
only part of the way for less speed and torque.
VARIABLE
SPEED
(Model
101231)
See Figure 4.
If you have this model, your drill has a variable speed
control selector designed to allow operator control and
adjustment of speed and torque limits. The speed and
torque of your drill can be increased or decreased by
rotating the variable speed control selector in the
direction of the arrows shown in figure 4.
Note: Hold your drill in normal operating position and
turn the variable speed control selector clockwise to
increase the speed and torque of your drill. Turn
9
Advertisement
