Fault Code Displays - Fisher & Paykel DD602I Use & Care Manual

FAULT CODE DISPLAYS
When a fault occurs, the light above the Start/Pause button is rt,d and secondary
pane[ light(s) inside the DishDrawer will indicate the type of iau[t which has occurred.
The DishDrawer will continuously beep eve W second until the Power button has been
pressed.
The lault codes are as iol[ows and we recommend that you check the chart below to
correct the iau[t where possible, if the iau[t cocle cannot be removed by pressing the
Power button, turn the Power off at the mains supply, wait 10 seconds and turn the
DishDrawer on again. When the red light above the Start/Pause button has
disappeared, run the DishDrawer on a wash program to ensure the l_tu[t has been
completely eliminated, if the iau[t code still appears, call your Fisher & Paykel
Authorized Service Agent.
You are reminded that if you call a Fisher & Payke[ Authorized Service Agent because
of a user faulh it is not covert, d by the Warranty. Should you encounter any problems
then we recommend that you telephone our Fisher & Paykel Customer Cart, Center on
888 9 367 872.
INDICATIVE LIGHTS
FAULT WHAT TO DO
Drawer • • Press the Power button
opet_ed to c]ear the fault,
during wash
Always
press the
Stal_Pause
button
before opening the
drawer if wash is i_
progress
h_correct • • • Change the wate_
water prr, ssulc_ setting to "HP".
_mssure Refer to Section on
semi[iS Optlon Adjustment
Mode.
Dlain pump Ck_al thc_ motol
hlock_,d assc_mbly o f foreign
matc_lial.Referto
Seclon on
User
Maintenance
instruction.
h_cormct
h_stailation Chr_ckthr_i_stailationto
ensurethe drai[i
hose(s)
are not kinked.
3f