Advertisement
Available languages
Available languages
HOWTOUSEYOURPRESSURE W ASHER
If you have any problems operating your pressure washer,
please call the pressure washer helpline at 1-888-222-3136.
PressureWasher Location
Prsssur8WashsrCJ88ranc8
_,
WARHIHG
_
Exhaustheat/gases can ignite
combustlbJes,
structures or damage fuel tank causing a fire.
• Keepat least5 ft. (152 cm) clearance on all sidesof pressure
washerincludingoverhead.
Place pressure washer outdoors in an area that will not
accumulate deadly exhaust gas. DO NOT place pressure
washer where exhaust gas (A) could accumulate and enter
inside or be drawn into a potentially occupied building.
Ensure exhaust gas is kept away from any windows, doors,
ventilation intakes, or other openings that can allow exhaust
gas to collect in a confined area. Prevailing winds and air
currents should be taken into consideration when positioning
}ressure washer.
WARHIHG
iRunning engine gives off carbon monoxide, an
odorless, colorless, poison gas.
Breathing carbon monoxide can cause headache,
ifatigue, dizziness, vomiting, confusion, seizures,
nausea,fainting or death.
• Operate pressure washerONLYoutdoors.
• Keepexhaustgasfrom enteringa confinedareathrough
windows,doors,ventilationintakes, o r otheropenings.
• DONOT start or run engineindoorsor in an enclosed area,
evenif windowsanddoorsare open.
To Start YourPressureWasher
To start your engine-powered pressure washer for the first
time, follow these instructions step-by-step. This starting
information also applies whenever you start the engine after
you have let the pressure washer sit idle for at least a day.
1.
Placepressure washer near an outside water source
capableof supplying water at a flow rategreaterthan
5.0 gallons per minute and no less than 20 PSi at pressure
washer end of garden hose.
2.
Check that high pressure hose is tightly connected to
spray gun and pump. See Assembly for illustrations.
3.
Make sure unit is in a level position.
4.
Connect garden hose to water inlet on pressure washer
pump.
t
HQTICE
DO NOT run the pump without the water supply connected
land turned on.
,
amageto equipment r esultingfrom failureto follow this
instructionwill voidwarranty.
5.
Turn ON the water, press red button on the gun and
squeezethe trigger to purge the pump system of air and
impurities.
6.
Attach nozzle extension to spray gun. Tighten by hand.
7.
Choose spray tip you want to use, pull back on collar of
nozzle extension, insert spray tip and releasecollar. Tug
on spray tip to make sure it is securely in place. See
How to Use Spray Tips.
8.
Movefuel valve lever (B) to "On" position.
(_
OFF
Advertisement
