Advertisement
Available languages
Available languages
3. Remove spray t ipfromend ofnozzle e xtension.
4. Use asmall paper cliptofree anyforeign m aterial
clogging o r restricting spray t ip(A).
5.
Remove nozzleextension from spray gun.
6.
Using a garden hose, remove additional debris by back
flushing water through nozzle extension. Back flush
between 30 to 60 seconds.
J
7.
Reinstall spray tip into nozzle extension.
8.
Reconnect nozzle extension to spray gun.
9.
Make sure garden hose is connected to water inlet.
Checkthat high pressure hose is connected to spray gun
and pump. Turn on water.
10. Start engine following instructions How to Start Your
Pressure Washer.
11. Test pressure washer by operating with each quick
connect spray tip.
O-Ring Maintenance
Purchasean O-Ring RepairKit at your local Searsor by calling
1-800-4-1VlY-NOIVlE (469-4663) or online at www.sears.com, it
is not includedwith the pressurewasher.This kit includes
replacemento-rings, rubberwasher and water inletfilter. Referto
the instruction sheetprovidedin the kit to serviceyour unit's
o-rings.
WARHIHG
The high pressure stream of water that this
_
quipment produces can cut through skin and its
underlying tissues, leading to serious injury and
3ossible amputation.
• NEVER repairleakingconnections with sealant o f any kind.
Replace o-ring or seal.
Pump Maintenance
ChangingPumpOil
Changeoil after first 50 hours of operation and then every
200 hours or 3 months, whichever occurs first.
NOTE:When changing pump oil, use only high quality SAE
30 weight oil. Use no special additives.
Changepumpoil as follows:
1.
Cleanarea around brass oil drain plug at bottom of
pump.
2.
Remove oil drain plug. Drain oil completely into an
approved container.
3.
When oil has completely drained, install oil drain plug
and tighten firmly.
4.
Cleanarea around pump oil dipstick. Remove dipstick
and fill pump with recommended oil to "Fuji" mark on
dipstick (typically 0.28 I or 9.6 oz.).
5.
install pump oil dipstick.
6.
Wipe up any spilled oil.
16
Advertisement
