Advertisement
Available languages
Available languages
ENGINEMAINTENANCE
WARHIHG
_
UnintentJonaJ sparking can resuJtJnfire or
_¢
electric shock.
WHENADJUSTING ORMAKINGREPAIRS TO YOUR
PRESSURE WASHER
• Disconnect t hespark plugwirefrom the sparkplug andplace
thewire whereit cannotcontactsparkplug.
WHENTESTING FORENGINE SPARK
• Useapproved spark plugtester.
• DONOTcheckfor sparkwith sparkplug removed.
Oil
Oil Recommendations
NOTE:When adding oil to the engine crankcase, use only
high quality 4-stroke automotive detergent oil ratedwith APi
service classification SJ or SL rated SAE 10W-30 weight. DO
NOT use special additives.
1.
Choose a viscosity according to table below.
ml
elo_.-3oem
m
ChangingEngineOil
Changeengine oil after the first 20 hours and every
100 hours or 6 months, whichever comes first, thereafter, if
you are using your pressure washer under extremely dirty or
dusty conditions, or in extremely hot weather, change oil
more often.
CAUTION
Avoid prolonged or repeatedskin contact with used motor
oil.
• Usedmotor oil hasbeenshownto causeskin cancerin certain
laboratory animals.
• Thoroughly washexposed areaswith soapand water.
KEEPOUT OFREACHOF CHILDREN.DON'T
POLLUTE.CONSERVE RESOURCES. RETURN
USEDOIL TO COLLECTION CENTERS.
Changeoil while engine is still warm from running, as
follows:
1.
Disconnect spark plug wire and keep it away from spark
plug.
2.
Placea suitable container below engine to catch used
oil. Removedipstick (A), drain plug (B) and washer.
3.
Allow oil to drain completely. Reinstall drain plug and
washer. Tighten drain plug securely.
4.
Place pressure washer on a level surface.
5.
Slowly pour recommended oil into oil fill opening (C).
Pauseto permit oil to settle. Fill to edge of oil filler hole.
-20
0
20
40
60
80
100 °F
-30
-20
-10
0
10
20
30
40°C
AMBIENT TEMPERATURE
NOTE:Other viscosities shown in the chart may be used
when the averagetemperature in your area is within the
recommended range.
CheckingOil Level
Oil level should be checked prior to each use or at least every
8 hours of operation. Keepoil level maintained.
1.
Make sure pressure washer is on a level surface.
2.
Cleanarea around dipstick. Removeoil dipstick and wipe
dipstick with clean cloth. Replacedipstick. Remove and
check oil level.
3.
Verify oil is at "Full" mark on dipstick. Replaceand
tighten dipstick.
AddingEngine 0il
1.
Make sure pressure washer is on a level surface.
2.
Check oil level as described in Checking Oil Level.
3.
if needed,slowly pour oil into oil fill opening. Pauseto
permit oil to settle. Fill to edge of oil filler hole.
4.
Replace and tighten dipstick.
j
6.
Screw in the dipstick and tighten securely.
7.
Wipe up any remaining oil.
8.
Reconnect spark plug wire to spark plug.
UPPER LIMIT
J
LOWER LIMIT
17
Advertisement
