Download Print this page

Craftsman 580.752360 Operator's Manual page 10

3000 psi 2.8 gpm
Hide thumbs Also See for 580.752360:

Advertisement

Available languages

Available languages

9.
Move throttle lever (A) to "Fast" position, shown as a
rabbit.
10. Move choke lever (B) to "Closed" position.
"
[
OPEN
CLOSED
NOTE:For a warm engine, be sure the choke lever is in the
"Open" position.
11. Move engine switch (C) to "On" position.
OFF
ON
IMPORTANT: Beforestarting the pressure washer, be sure
'ou are wearing adequatesafety goggles.
WARNING
_,_
Risk of eye injury.
"
Spray can splash back or propel objects.
• Alwayswearsafetygoggleswhenusingthis equipment o r in
vicinityof whereequipment i s in use.
• Beforestartingthe pressure washer,be sureyouare wearing
adequate safetygoggles.
• NEVER substitutesafetyglassesfor safetygoggles.
12. When starting engine, position yourself as
recommended and grasp starter grip handle and pull
slowly until you feel some resistance.Then pull rapidly
to start engine.
WARNING
Starter cord kickback (rapid retraction) can result
_nbodily injury. Kickback will pull hand and arm
_,_,_<
toward engine faster than you can let go.
Broken bones, fractures, bruises, or sprains
could result.
• NEVERpull starter cord without first relieving spray gun
pressure.
• When starting engine, pull cord slowly until resistance is felt
and then pull rapidly to avoid kickback.
• After each starting attempt, where engine fails to run, always
point spray gun in safe direction, press red button and squeeze
spray gun trigger to releasehigh pressure.
• Firmly grasp spray gun with both hands when using high
pressure spray to avoid injury when spray gun kicks back.
3. Return recoil starter slowly. DO NOT let rope "snap
back" against starter.
14. When engine starts, slowly move choke lever to "Open"
position as engine warms. If engine falters, move choke
lever to "Closed" position, then to "Open" position.
15. If engine fires, but does not continue to run,always point
gun in safe direction, press red botton and squeezespray
gun trigger to releasehigh pressure. Move choke lever to
"Open" position, and repeatsteps 12 through 14.
16. If engine fails to start after six pulis, move choke lever to
"Open" position, and repeatsteps 12 through 14.
NOTE:Always keep the throttle lever in the "Fast" position
when operating the pressure washer.
10

Advertisement

loading